Roofing referrals for Seattle & nearby townsCall: (206) 984-7830
(206) 984-7830

Torch-Down Roofing in Federal Way, WA

roofingseattle.net

Garage roofs, porch roofs and additions in Federal Way often carry a torch-applied cap sheet, and a local roofer can service it.

Flat roof leaking at the laps in Federal Way?
Call now to be connected with a local roofing contractor in Federal Way.
(206) 984-7830

Torch-down roofing is modified bitumen sheet that a roofer bonds to the roof by heating the underside with a propane torch. It is built in layers, with a cap sheet on top. Call the number on this page to be connected with a local roofing contractor in Federal Way.

Roofers unroll modified bitumen roofing on a flat roof with safety equipment staged nearby, torch-down roofing in Federal Way, WA

A material built from separate parts

The membrane, the flashings at walls, the metal edge and the drains all matter on a torch-down roof. A leak can come from any of them. The surface may look fine while the weakness hides where the sheet turns up a wall. Ask the roofer to check each one.

Preparing the property for torch work

Owners can help by moving vehicles, patio furniture and stored items away from the building and clearing the area below. Tell the roofer about attic access, gas meters or anything unusual nearby. The roofer takes it from there. Keep children and pets indoors while work is under way.

Call now to be connected with a local roofing contractor in Federal Way.
(206) 984-7830

Low spots and standing water

Modified bitumen tolerates some ponding, but constant puddles speed wear and loosen seams. A low area from settled framing or a poorly placed drain is a common cause. The roofer should look at drainage as well as the damage. Fixing the slope can matter as much as patching.

What shapes the cost

Size, number of layers, deck condition, flashing complexity and roof access all affect price. A simple rectangle costs less than a roof broken by chimneys, vents and walls. Each independent roofer sets his own price after seeing the roof. Ask each roofer to explain what is included in the bid.

Permits, weather and roofs in Federal Way

Building permits for Federal Way homes are handled by the City of Federal Way permit office. Small repairs often need nothing, while a tear-off, new sheathing or structural work usually does, so ask the roofer who pulls the permit.

Before work begins, look the company up on L&I's Verify a Contractor page. Washington requires construction contractors, roofers included, to be registered.

Most roof trouble in this part of Washington shows up in the wet season, when a small gap in flashing or a lifted shingle has months of rain to work on.

Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.

If the damage came from a storm, write down the date and keep your photos; you may want them for an insurance claim.

Contractors that take calls here usually also work in Milton, Des Moines and Fife.

What to ask the roofer

  • How do you protect the building from the torch?
  • Will you strip or recover the old roof?
  • What happens at walls, drains and edges?
  • What manufacturer warranties apply to the material?

Get answers before work starts. Get answers before work starts and keep notes of what each roofer says.

Around Federal Way

Calls come in from across Federal Way, including around Camelot, East Redondo, Dash Point State Park.

Federal Way grew as a commuter suburb along I-5, and much of its housing comes from later suburban development.

Torch-Down Roofing questions in Federal Way

What is torch-down roofing?
It is a rolled modified bitumen roofing system. A roofer heats the underside of each sheet with a propane torch so it fuses to the layer beneath, forming layered, waterproof seams on low-slope roofs.
Can I install or repair torch-down roofing myself?
No. Open flame near wood framing is a serious fire risk, and poor technique leads to leaks. Leave all torch-applied work to roofers with the training and equipment.
What does a failing torch-down roof look like?
Look for open seams, bare asphalt where granules have worn off, blisters, cracks near walls and water that stays in puddles. Stains on the ceiling below are another sign.
Can I put a coating over a torch-down roof?
Sometimes. A coating can extend a sound, dry roof by protecting the surface. It will not fix wet insulation or open seams, so a roofer should check the roof first.

More roofing services in Federal Way

Torch-Down Roofing nearby

Call now to be connected with a local roofing contractor in Federal Way.
(206) 984-7830

Last updated:

☎ Call (206) 984-7830