Roofing referrals for Seattle & nearby townsCall: (206) 984-7830
(206) 984-7830

Roof Flashing Repair in Medina, WA

roofingseattle.net

Before replacing a whole roof, find out whether a flashing repair would solve the leak at your Medina home.

Water by the dormer in Medina?
Call now to be connected with a local roofing contractor in Medina.
(206) 984-7830

A leak that starts at a joint, a pipe or a wall is usually a flashing problem rather than a worn roof. Fixing only that detail can keep a sound roof going. Call the number on this page to be connected with a local roofing contractor in Medina.

A gloved roofer replaces step flashing along the joint where a roof meets a wall, roof flashing repair in Medina, WA

It leaks only in some rains

Flashing leaks often show only in wind-driven rain or heavy downpours, because water has to be pushed sideways to reach the gap. If a stain appears after storms but not in light rain, a joint rather than the field of shingles is a likely suspect.

Wall and headwall flashing

Where a roof runs into the front of a wall, such as above a dormer or an addition, a continuous piece of flashing is covered by siding or counter-flashing above. If the siding is tight or caulked wrongly, water can slip behind it and reach the sheathing.

Call now to be connected with a local roofing contractor in Medina.
(206) 984-7830

Rotted decking changes the job

If water has leaked for a long time, the plywood under the flashing may be soft. Replacing a section of decking adds labor and material to the repair. Ask the roofer to explain what they find and to show you photos before agreeing to extra work.

Roof notes for Medina

If the job grows from a patch into a full reroof or framing repair, check with the Medina Development Services before work starts.

Before work begins, look the company up on L&I's Verify a Contractor page. Washington requires construction contractors, roofers included, to be registered.

Months of steady rain, shaded roofs and mild temperatures make moss and debris a constant here. Gentle removal is better for shingles than a pressure washer.

Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.

Write down when the leak appears: every rain, only in wind-driven rain, or only after snow. That detail points straight to the cause.

Contractors that take calls here usually also work in Bellevue, Mercer Island and Kirkland.

Questions for the roofer

  1. Which flashing failed, and what caused it?
  2. Will the repair use metal, or just sealant?
  3. Do the surrounding shingles need to be lifted?
  4. Is the decking underneath sound?
  5. What should I watch for afterward?

Clear answers are a good sign.

Mold and moisture worries

Persistent dampness near the roofline can encourage mold in insulation and drywall. Stop the water first, then ask about drying and cleanup. Do not disturb large dark patches yourself; describe them to the roofer, who can say whether another specialist should be consulted.

Roof Flashing Repair questions in Medina

What is roof flashing?
Flashing is thin metal or molded material installed where roof planes, walls, pipes and edges meet. Its job is to direct water over joints instead of letting it slip behind the shingles.
What is the difference between step and counter-flashing?
Step flashing is layered with shingles along a wall, while counter-flashing is a cover piece that sheds water over the top of base flashing. Many joints use both.
How often should flashing be checked?
A look every few seasons and after major windstorms is a sensible habit, especially in shady or mossy areas. Early catches are inexpensive.
Is it safe to climb up and check flashing myself?
No. Wet or mossy roofs are slippery, and metal edges are sharp. Use binoculars from the ground and the attic flashlight check instead.

More roofing services in Medina

Roof Flashing Repair nearby

Call now to be connected with a local roofing contractor in Medina.
(206) 984-7830

Last updated:

☎ Call (206) 984-7830