Flashing is the thin metal that seals the joints where a roof meets a wall, vent, chimney or valley, and it is a frequent source of leaks. In a rainy city like Seattle, small gaps let in water for months before a stain appears. Call the number on this page to be connected with a local roofing contractor in Seattle.

What flashing does
Water runs down a roof and collects where surfaces meet. Flashing carries it over those joints and onto the shingles below. It is used along walls, around plumbing vents and skylights, in valleys, and at roof edges. Over time it can corrode, bend in wind, pull loose, or lose its sealant.
Signs of flashing trouble
- Stains on a ceiling or wall that line up with a roof joint or chimney
- Water marks in the attic near a vent pipe or wall
- Rust, gaps or lifted metal visible from the ground with binoculars
- Leaks that show up only in driving rain, common during Seattle windstorms
Do not climb up to look. Wet roofs and moss are slippery. Place a bucket under any drip, move valuables, and photograph stains from inside.
Seattle conditions that stress flashing
NWS puts most Sea-Tac precipitation between October and March, and Puget Sound windstorms are a winter pattern, so flashing is tested by both rain and wind. Moss and needle buildup in valleys and against walls can hold water on the metal. Older craftsman homes may have original flashing that has outlived the roofing around it, and tree-shaded Seattle roofs collect debris that keeps those joints wet.
What happens on the call and the visit
Describe where the water shows up and when. A local roofer checks the suspect joint and the flashing around it, often finding that sealant alone will not hold and the metal needs replacing. Ask whether the repair involves lifting shingles, what material is used, and whether the nearby roofing is sound enough to repair rather than replace.
What it costs
Thumbtack's national average for roof flashing repair runs about $569 to $2,536 per job. Angi's national figure for flashing other than chimney is about $200 to $500. Chimney flashing is usually priced separately, and costs vary with roof height and complexity.
Hiring a roofer
Washington roofers must be registered with L&I. Use L&I's Verify a Contractor tool to confirm an active registration, ask for a written bid with the scope and materials, and ask who cleans up. For a large reroof, Seattle SDCI says a permit is required when repairing an area greater than 500 square feet.
Roof Flashing Repair questions from Seattle homeowners
How much does roof flashing repair cost?
How do I know it is the flashing leaking?
Can I patch flashing with caulk?
Is flashing repair covered by insurance?
Related roofing services in Seattle
Helpful guides
Roof Flashing Repair in nearby cities and towns
King County
Snohomish County
Pierce County
Kitsap County
Island County
Mason County
Jefferson County
Sources
Last updated: