Flashing is thin metal or molded material that directs water away from places where roof planes, walls and pipes meet. When it rusts, lifts or splits, leaks follow, but the shingles may be fine. Call the number on this page to be connected with a local roofing contractor in Snohomish.

Old patches and sealant
Tar or caulk around a joint signals that someone chased a leak before. Sealant dries and cracks within a few seasons, and it can hide the true entry point. Roofers often remove it and rebuild the flashing correctly instead.
Wall and headwall flashing
Where a roof runs into the front of a wall, such as above a dormer or an addition, a continuous piece of flashing is covered by siding or counter-flashing above. If the siding is tight or caulked wrongly, water can slip behind it and reach the sheathing.
Needles and moss from tall firs and cedars pile in valleys and at wall joints, holding water against the flashing and speeding rust, so cleaning and repair often go together.
Access and height
A single-story gable is far easier than a three-story house with a steep, mossy slope and tight side yards. Extra safety gear, staging and wet conditions all add time. A few photos from the ground help the roofer estimate before the visit.
Questions for the roofer
- Which flashing failed, and what caused it?
- Will the repair use metal, or just sealant?
- Do the surrounding shingles need to be lifted?
- Is the decking underneath sound?
- What should I watch for afterward?
Clear answers are a good sign.
Contain the drip
Place a bucket under the leak, move belongings aside and lay a towel to stop splashing. Photograph the stain with the date. If the ceiling bulges with trapped water, call quickly and keep clear of that spot, especially near light fixtures.
Before you call in Snohomish
Permit note from the City of Snohomish permit office: The city FAQ states a building permit is required for any new construction, remodel, repair, demolition, change in use or conversion; it does not specifically address re-roofing, so confirm with the Permit Center.
A quick check that pays off: enter the contractor's name in L&I's online verify tool to confirm an active Washington registration.
Months of steady rain, shaded roofs and mild temperatures make moss and debris a constant here. Gentle removal is better for shingles than a pressure washer.
Tall evergreens around Snohomish drop needles that fill valleys and gutters and keep roofs shaded and damp, which is where moss starts.
Storm took out power too? Report it to Snohomish PUD at 425-783-1001, and stay clear of any downed line.
Contractors that take calls here usually also work in Everett, Monroe and Lake Stevens.
Roof Flashing Repair questions in Snohomish
What is roof flashing?
How do I know if a leak is from flashing?
Is roofing cement a good fix for flashing leaks?
Is it safe to climb up and check flashing myself?
More roofing services in Snohomish
Roof Flashing Repair nearby
Helpful guides
Sources
Last updated: