Roofing referrals for Seattle & nearby townsCall: (206) 984-7830
(206) 984-7830

TPO Roofing in Gig Harbor, WA

roofingseattle.net

Pinholes, open seams or a worn white surface on a TPO roof in Gig Harbor? A local roofer can inspect the membrane.

Pricing TPO for a Gig Harbor building?
Call now to be connected with a local roofing contractor in Gig Harbor.
(206) 984-7830

TPO is a single-ply membrane made from thermoplastic polyolefin, usually white, with seams that a roofer welds together with hot air. It is rolled across the roof in wide sheets. Call the number on this page to be connected with a local roofing contractor in Gig Harbor.

A worker uses an automatic welder on the seam of a white TPO membrane on a commercial flat roof, tpo roofing in Gig Harbor, WA

What a TPO roof is

TPO is a thermoplastic single-ply membrane supplied in wide rolls, most often white or light gray. A roofer lays it over insulation and welds the overlaps with hot air, so the seams become part of the sheet rather than a glued joint. Most residential jobs use the same basic method.

Flashings and corners need extra care

Walls, pipes, curbs and corners require cut pieces and hand welding. These spots take the most thermal movement and the most attention. If a leak is near a penetration or corner, the roofer will start there. Ask the roofer whether corners and penetrations are welded by hand or pre-formed.

The median home here was built in 1996, so many flat or low-slope sections are original and nearing replacement age, and some associations have rules about membrane color and appearance.

Wind off the water pulls hard at the edges of a single-ply roof, so shoreline buildings often need extra fasteners and strong edge metal.

Call now to be connected with a local roofing contractor in Gig Harbor.
(206) 984-7830

Tear-off or recover

A new TPO sheet can sometimes go over an older roof if it is dry and sound. If the old layers hold moisture, the roofer may recommend a tear-off. That choice changes disposal, labor and timing quite a bit. Ask the roofer to show you moisture readings that support the recommendation.

Know this about Gig Harbor roofs

Building permits for Gig Harbor homes are handled by the City of Gig Harbor permit office. Small repairs often need nothing, while a tear-off, new sheathing or structural work usually does, so ask the roofer who pulls the permit.

Washington L&I registers construction contractors. Its free lookup shows whether a roofer's registration is active and whether there are claims against it.

Homes near the water around Gig Harbor take more wind and salt exposure, which wears metal flashing and fasteners faster.

Fall and winter windstorms are the main source of sudden roof damage around Puget Sound. Lifted tabs and loose ridge caps are worth a look after a blow.

Tall evergreens around Gig Harbor drop needles that fill valleys and gutters and keep roofs shaded and damp, which is where moss starts.

Contractors that take calls here usually also work in University Place, Olalla and Fox Island.

Apartments, condos and shops

On multifamily and commercial buildings, TPO's wide rolls and quick patches fit occupied properties. Managers value clear scopes and schedules. Ask how the work will be staged so tenants stay safe and noise stays reasonable. Ask whether the roofer has worked on occupied properties like yours and how that went.

If a TPO roof is leaking now

Stay off the roof. Set a bucket under the drip, move belongings, photograph the stain and tell the roofer when it began. If water reaches light fixtures or outlets, shut off power to that area and keep clear. Take photos if you can do so safely.

TPO Roofing questions in Gig Harbor

What does TPO stand for?
TPO stands for thermoplastic polyolefin. It is a flexible plastic-based membrane that softens when heated, which is why roofers can weld the seams together with hot air.
Is TPO good for a residential flat roof?
It can be. TPO is common on flat additions, porches and modern low-slope homes. A roofer can explain whether it fits your roof's slope, drainage, insulation and appearance.
Can a TPO roof be repaired?
Yes. Small punctures, open seams and loose flashings are usually patched by cleaning the area and welding on new membrane. Very old or brittle sheets may not weld well.
Can TPO go over an old roof?
Sometimes, if the existing roof is dry, sound and allowed by local rules. If the old layers hold moisture, tearing off first is usually better.

More roofing services in Gig Harbor

TPO Roofing nearby

Call now to be connected with a local roofing contractor in Gig Harbor.
(206) 984-7830

Last updated:

☎ Call (206) 984-7830