TPO roofing is a single-ply thermoplastic membrane, usually white, whose seams are welded with hot air to form a watertight sheet. It is common on commercial buildings and low-slope residential roofs. Call the number on this page to be connected with a local roofing contractor in Seattle.

What TPO is
TPO stands for thermoplastic polyolefin. The membrane comes in wide rolls and is attached with fasteners or adhesive over insulation board, then seamed with a hot-air welder. It reflects heat, which matters more on a commercial roof than on a Seattle house, but its clean seams and light weight are the reasons many owners ask about it.
Where it fits in Seattle
Seattle has plenty of low-slope roofs: shop buildings, apartment blocks, mixed-use storefronts, townhouse decks and modern homes with flat sections. NWS puts the Sea-Tac rainy season at October through March, so the membrane sits wet for months. Quality depends on the details: how seams are welded, how walls and penetrations are flashed, and how the insulation and drains are laid out. Debris and fir needles still need clearing from drains, and rooftop equipment traffic can puncture the sheet.
Signs a TPO roof needs attention
- Seams that have opened or edges peeling at walls and curbs
- Punctures, cracks or worn patches near vents, drains and walkways
- Ponding that lingers or ceiling stains below the roof
Look from a window, upper floor or the ground. Do not walk the membrane to check. It can be slick when wet and low-slope roofs often lack edge protection.
What happens on the call and the visit
Tell the contractor the roof size, age and where water shows up. A roofer will check seams, flashing, drains and insulation and say whether the answer is a patch, a section replacement or a full re-cover. Ask for the membrane thickness, how it is attached, the flashing plan, and what the manufacturer's warranty on the material covers.
What it costs
HomeGuide's national guide lists an installed TPO roof at roughly $4 to $10 per square foot, and TPO flashing repair at about $200 to $500 per job. These are national figures and a Seattle bid depends on size, access, insulation and tear-off.
Permits and hiring
Seattle SDCI says replacing roof cover on commercial and multifamily projects requires a re-roof permit, and repairing an area over 500 square feet does too. Washington roofers must be registered with L&I; use Verify a Contractor to check registration, workers' comp and citations, and ask who pulls the permit.
TPO Roofing questions from Seattle homeowners
What does TPO stand for?
How much does a TPO roof cost?
Is TPO only for commercial buildings?
Do I need a permit for a TPO roof in Seattle?
Related roofing services in Seattle
Helpful guides
TPO Roofing in nearby cities and towns
King County
Snohomish County
Pierce County
Kitsap County
Island County
Mason County
Jefferson County
Sources
Last updated: